WaterArmor® – Waterproofing Products

T. Clear Corporation’s WaterArmor AWB is a high quality 100% acrylic flexible air and water barrier.  WaterArmor AWB is intended for roller or spray application, but can also be troweled or brushed into place.  WaterArmor AWB forms a continuous air and water barrier that protects approved substrates from incidental water damage.

  • Available in 5 gallon pails
  • 100% Coverage
  • Doesn’t rattle in the wind
  • Vapor permeable with low air infiltration rate
  • Used as water barrier and flashing

 

T. Clear Corporation’s WaterArmor TG is a high quality, flexible trowel grade joint treatment and water barrier.  With a 12-perm rating WaterArmor TG may be applied as a continuous flashing at penetrations and openings.

  • Available in 5 gallon pails
  • Provides a water barrier continuous flashing at penetrations, panel joints and openings
  • Easily applied with trowel or stainless steel taping knife

 

T. Clear Corporation’s WaterArmor LF is a gun grade flashing and waterproofing.  Formulated with STPE polymers, WaterArmor LF uses moisture curing to produce a highly durable, seamless, elastomeric flashing membrane.  Fast curing allows for same day installation of windows, doors and other wall assembly, waterproofing or air barrier components.

  • Available in 20 oz sausages
  • Streamlines preparation by eliminating the need for joint reinforcing tapes
  • Silane functional polymer provides superior long term adhesion, crack bridging and weathering characteristics
  • Produces an opaque membrane when installed at the recommended 12-15 mils to simplify inspection and quality control
  • Bonds to most common building materials without priming
  • Single component saves time – no mixing
  • Produces a durable, weather-tight seal and will bond and cure in wet weather on damp substrates

 

T. Clear Corporation’s WaterArmor Flashing Tape is a lightweight roll flashing material with superior strength and the ability to bridge most gaps or voids common in construction.  Embedded into wet WaterArmor AWB or TG, it is used at flashing transitions and panel joints.  The tape easily embeds into wet WaterArmor and dries to a highly reinforced yet flexible flashing.

  • Available in 4″, 6″ and 9″ widths in 180′ rolls
  • Lighweight
  • Embeds easily
  • Thin, won’t build up wall surface

 

See data sheets for list of approved substrates, specifications and product test standards.